*When adjusting gain, think of the colors on the volume indicator like a traffic light. Remember the gain changes everything on the channel including the monitor levels, so be ready if a monitor starts to feedback, or if you are turning the gain down readjust the person’s monitor level back up if needed. If a fader has to be turned up very high or brought down very low, and you have made sure it is still working properly, or basically you know why it changed from the sound check, you can adjust the mic-pre to position your fader better. Now with the band playing you can adjust the channel faders for the overall mix. You may need to adjust the gain up or down a little to get the level in the monitors right, but if you started at the 0dB setting you should be able to set the monitors with just the channel monitor level. This 0dB method lets you now set all the channel faders to 0dB and bring up the master faders as needed. Note: any boosting of equalization on that mixer channel will also increase the overall gain, especially if you are heavily boosting certain frequencies. Gain settings much higher on this first setting will lower the dynamic headroom available for adding EQ adjustments, or may be to high when a player turns up or just plays harder during the show. Of course more dynamic instruments will bounce around on the meters, so a setting of under +6dB is fine. Now you can watch the full meter readings for that channel and set the level to 0DB on the meters. If your mixer has a SOLO with pre fader or PFL (Pre Fader Listen) feature, press that button and your input level pre- fader should show up on your main meters. This is always the tricky part, because often a player will not really play at performance level, because they are the only person playing. Then play the corresponding instrument at a normal performance level. The simplest way to set gain on a console is to turn the channel output fader all the way down, and mute the channel in case a pre fader monitor is turned up. If you have to use the clip method, watch the clip indicator often, so you can back it off more if you see clipping later in the show. Clipping will result in a harsh distorted sound, and may lead to speaker damage, so it should be avoided. This method brings the level up to just flashing the clip indicator and then backs it off to no clipping, and then a little lower. This is more of a studio method and can run into problems in live settings. If you don’t have a channel meter indicating a 0dB level or solo meters, you can use the channel’s signal and clip indicator to set the level. This level is often set at 0dB on the meter. The first goal when setting the knob is to bring all inputs up to a common level. Your microphone may be louder like in the case of a wireless microphone the output of the unit may be much higher than a simple wired microphone.Ī microphone’s output is usually very low compared to a keyboard or guitar, so changes to the gain setting will be required when using different instruments or devices. You don’t have to use this button if you are using a microphone as long as you are getting enough volume without it. This button’s function is the same as a knob. Note: On some smaller mixers and power amp combo mixers the gain knob is replaced by a button that may be labeled “-20dB” or “mic gain”. The purpose of the knob is to control the input volume of any instrument or microphone that you have plugged into that channel of the mixer or console. The term “trim” is also used, because it relates the high gain of the microphone pre-amp and the knob’s trimming back this gain. This knob, also referred to in some instances as the trim knob, is the first point of amplification and entry into your mixer. Knowing how to properly set the gain on each channel of your mixing console can go a long way in ensuring an optimal live or studio mix for your band.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |